!!

Welcome to our Forum, extension and content sharing platform of Electrical Test and Measurement Product Reviews Blog.

 
Registration this is Free, we accept contributors of 17 years old and above. We do not accept registration with Gmail

Active since 7 June 2012  


Copyright Notice: Entire ITTSB.EU content & images they are copyright protected. - Forum search engine disabled to Guests - No need of you using Adblock software.

Author Topic: Differential probe comparison at low volts GW Instek GDP-040D VS PINTEK DP-50  (Read 8254 times)

0 Members and 1 Guest are viewing this topic.

Online Kiriakos GR

  • Administrator
  • Hero Member
  • *****
  • Join Date: May 2012
  • Location: Greece
  • Posts: 2304
  • Country: gr
    • ittsb.eu
  • job title: Industrial Maintenance Electrician
This small presentation is all about expectations when using a differential probe.
The first personal lesson that I got by purchasing my own AC/DC current clamp probe which this is mainly to be connected to an Oscilloscope is that all active probes even if them measuring nothing, they do output few millivolts and them are described as noise.

At current clamp probes when using them for DCA measurements’, their button about zero-out is very handy, this helps their output to get close to zero, and the actual measurement is close to be called as accurate.
But at active differential probes what ever noise is produced by their own electronics it gets out in the form of some mV and even them are added to the final measurement.

A bit of noise in those Differential probes is not a big deal if you need plain voltage measurements’ at the range of several hundreds of volts.

But when you need to troubleshoot pulses by your Oscilloscope, this output noise it can become your enemy.

The test bed in my testing is a pulsing battery charger, at charging mode this produce a positive pulse so this to charge 1.5V Ni-mh battery.

I thought to test GDS-2102A by using channel 1 with it normal probe, and at channel 2 I did connect the PINTEK DP-50 probe.
The noise of PINTEK DP-50 probe at that low voltage is huge.
Then I thought to use GDS-320 Oscilloscope with GDP-040D so to discover how this performs in the specific application. 
The results of my tests are now presented bellow by pictures.
   
My own fresh experience and lesson is that from now and on I will never use again PINTEK DP-50 probe at probing anything bellow 5V DC.

This GDP-040D shown much better behavior over all, and it did demonstrated correctly the pulse signal with good detail.

To my readers I will say to be careful when selecting a differential probe, my  story is one good example of what it can happen when you using probes designed almost one or two decades back with Oscilloscopes’ of our times.
WWW.ITTSB.EU   Industrial Test Tools Scoreboard  (Product Reviews Blog) / Editor in Chief.
The content of this Web site is copyright protected

 

ITTSB.EU Blog

General Data Protection Regulation GDPR ITTSB.EU Home Page Reward us by a Donation - Sponsorship TsDMMViewer Data Logger for FLUKE 884xA

ITTSB Blog - Sponsors

protosnet.com - Internet solutions FLUKE benchtop DMM Repair Services

Recommended Links

Hellenic Accreditation System E.SY.D. Portal of city Volos - Greece Clean Up and Customize Facebook Firefox Backup Tool 32bit / 64 bit Winaero Tweaker = Win7 Fonts size fix